Radio Autmation Software | BSI
Simian 2.3 Now Available with Support for Windows XP, 7, 8/8.1, and 10 on 32bit or 64bit platforms!
October 23, 2017
View Cart

DR-10

Dial-up Remote Control

Perfect for ball-games, remotes, or news & traffic flashes, the DR-10 is a user programmable remote control unit that lets you operate your radio station from anywhere there's a telephone and / or feed live telephone reports to air!

As well as going 'live', the DR-10 could be used to monitor an external audio source (for EAS monitoring, remote controlled audio switcher, etc.) or to start one of Simian's background recorders for later broadcast by sending a relay closure to a trigger interface.

A second, user set password is available that allows the DR-10 to be used as a listening device only. When the secondary password is entered, the DR-10 passes audio to the caller and will stay on-line, but the caller has no control over the unit's relays.

Additional ground sink outputs occur when the DR-10 seizes the phone line and when it hangs up. A disable input allows an external device such a timer, switch or automation system to de-activate the DTMF decoder which lets you choose when others gain remote access to your equipment.

The DR-10 automatically answers the phone on a user set number of rings and waits for you to enter your password (from none to 8 digits). After entering your password, you have complete control of the DR-10's relays. They can be individually programmed for momentary, latching or interlocked operation.

Each relay can be programmed to decode any of the 16 DTMF tones. Any relay can be tied to any other for modes such as latching and interlocked. Relays can return a beep acknowledge tone that tells you when you've activated an output.

The DR-10 includes a two-tone sequence mode that prevents accidental contact closures when you're using it for remote broadcasts.

The DR-10 has four logic level inputs that can cause the DR-10 to automatically activate any relay and / or call your pager. When an alarm happens, the DR-10 can tell you which channel caused the alarm with a series of beeps. Each status/alarm input can dial a different number up to 24 digits long including pauses.

The DR-10 dial-up remote control is perfect for studio & automation control.

Features

  • 10 N.O Dry relay contacts out (2 are DPDT for easily switching balanced audio, etc.).
  • Auto-answers on user selectable ring number and auto-drops at call's end.
  • Each relay can be independently set to function as a momentary closure, latching closure with distinct on/off codes, or interlocked latching with other relays.
  • Individual relays can be programmed to close at beginning or end** of tones.
  • Up to 8-digit user-settable password prevents pirating.
  • A second password can be assigned to allow listening without control functions.
  • Any relay can be assigned to any tone(s).
  • Momentary or latching open collector output when the DR-10 goes on-line.
  • Momentary open collector output when it hangs up.
  • Exclusive, Two-tone & detection delay modes eliminate falsing.
  • 4 Status inputs can dial 4 numbers and control relays.
  • A simple, built-in audio hybrid lets you control equipment while monitoring a local audio source.
  • Each relay is programmable to beep when activated.
  • Provides active, balanced, phone line audio input and output.
  • All outputs appear on easy to use screw terminals.
  • Program it with any DTMF phone or encoder.
  • Retains its settings after a power failure.
  • Rugged, metal case can be table, wall or, optionally, rack mounted.
  • The DR-10's first 5 relays can be programmed for binary mode allowing easy interfacing to computers, video or audio routing switchers, etc.

Price

$399.00

QTY: